Community
Hello, I already defined the limiting width of cracking in the ROBOT as below.
Can ROBOT véfier the calculated cracking of the structure, can it give a small calculation report of verification? if it could, where I can find the report?
Either as maps or in reinforcement results table as additional columns
Rafal Gaweda
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")