Discussion Groups

Robot Structural Analysis

Reply
Product Support
Rafal.Gaweda
Posts: 4,924
Registered: ‎04-26-2010

Re: Section builder

02-04-2013 12:42 AM in reply to: aruser

Look below

 

convtosolid.jpg



Rafal Gaweda
Please use plain text.
Active Member
pawel_t
Posts: 6
Registered: ‎06-02-2013

Re: Section builder

06-13-2013 05:05 AM in reply to: Rafal.Gaweda

Hi,

 

I put from a Cad a Z section. How to read a wraping constant  from "Result" ?

 

Regards

Please use plain text.
Product Support
Rafal.Gaweda
Posts: 4,924
Registered: ‎04-26-2010

Re: Section builder

06-13-2013 05:14 AM in reply to: pawel_t
Please use plain text.
Active Member
pawel_t
Posts: 6
Registered: ‎06-02-2013

Re: Section builder

06-13-2013 05:39 AM in reply to: Rafal.Gaweda

I have a doubt if in my Principal System is wraping constant.

 

Could check my ad?

Please use plain text.
Product Support
Rafal.Gaweda
Posts: 4,924
Registered: ‎04-26-2010

Re: Section builder

06-13-2013 07:50 AM in reply to: pawel_t

This section is defined as a thick walled, not thin walled section.

 

eThin walled section results Example below

 

thinw.jpg

 

Start Thin walled section, import only centerline of section, then assign \ set correct thickness



Rafal Gaweda
Please use plain text.
Active Member
pawel_t
Posts: 6
Registered: ‎06-02-2013

Re: Section builder

06-13-2013 08:17 AM in reply to: Rafal.Gaweda

Thank you very much. This works.

Please use plain text.