Robot Structural Analysis Forum
Welcome to Autodesk’s Robot Structural Analysis Forums. Share your knowledge, ask questions, and explore popular Robot Structural Analysis topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Panel load distribution

5 REPLIES 5
SOLVED
Reply
Message 1 of 6
GabrieleNovembri1027
600 Views, 5 Replies

Panel load distribution

Hi All,

I am trying to analyze a structure using a unidirectional slab without f.e.. The verification of the structure give always the same advice " The he load  ...." as shown in the picture.

Cattura1.PNG

 

The distribution of load seems anyway correct as shown in the picture.

Any suggestion, How I can understand if and where the things are going wrong ?

 

Thanks

5 REPLIES 5
Message 2 of 6

On my simple model everything works fine.

Please send me your model

 

warn.jpg



Rafal Gaweda
Message 3 of 6

Hi Rafal,

You will find attached the RTD file of the part of the model that causes the error. It is portion of a very big structure and I have isolated the part with the problem as shown in the picture (the attached file is only a little part of the substructure in the picture). I have created constraints and so you can run the analysis. The selected panels give the error.

Thanks

 

raphal.PNG

Message 4 of 6

You are right. Loads are generated correctly but the misleading (in this case) warning message is displayed.

 

One hint: if you want to neglect some bars in claddings loads generation use Geometry \ Additional Attributes \ Loads Distribution Options -> .... Ignore

 

ignore.jpg





Rafal Gaweda
Message 5 of 6

 
Message 6 of 6

Hi Rafal,
Thanks a lot.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report