Nothing happens after Automatic Load Combinations

[Anonymous]

Hi

I have a model, in which I have changed the code combination regulations and member regulations quite a few times, and generated Combinaitons. Its working fine.

But when I changed them back and when I click generate in Automatic Combinations, nothing is happening. 

I have found a Thread with the same problem (below is the link), I have tried the selected solution, but it is not working. 

http://forums.autodesk.com/t5/Robot-Structural-Analysis/Problem-with-generating-automatic-combinatio...

[Rafal.Gaweda]

File please.

[Anonymous]

Hi Rafal, 

I have attached the file. 

I have sent the password for the zip file as private message to you.

[Rafal.Gaweda · Accepted solution]

I do not see any problem.

Keep in mind that automatic code combinations are generated automaticaly AFTER finishing FEM calculations, not just after pressing Generate in Code Combination window.

[Anonymous]

Thank you Rafal

I always check the combinations after clicking the Generate button. Thats my mistake I guess. 

[engsam777]

rafal, why is that the generated automatic combinations does not include earthquake load definition when the calculation is runned but only dead,live and wind.

[Rafal.Gaweda]

It depens on code used (if it includes seismic cases \ combinations).

See example below:

[engsam777]

thank you, that suggest that if it doesnt support, then i need to enter it as a manual combination.correct?

[Rafal.Gaweda]

Yes, in such case select correct combination type: