Member list is incorrect

[SteveGregan]

Morning, 

I am having the issue when performing steel design of structural piles. 

When i try to calculate, there is an error ``Member list is incorrect``.

I am also unable to include any members, but the structure does analyse.

Any suggestions how to correct the error?

Thanks

Steve 

[andrea_pontiggia]

I too have had a similar problem. I had changed a concrete pillar with a steel.

Check the following settings.

Also try resetting the design parameters of the regulations

[SteveGregan]

Thanks, i have tried what you suggested by i still seem to have a problem with the model. 

Will keep at it.

[SteveGregan]

I am unable to select any members to verify. 

Have a look at the attached photos.

Steve

[Rafal.Gaweda · Accepted solution]

Either wrong material (not steel) in assinged to members or steel member types are not assigned to bars.

If it is not the case please send us  model.

[SteveGregan]

Thanks Rafal,

I have corrected the error.
Since I exported the nodes and members from SAP2000 into Excel and then into Robot, the elements were not specified as a simple bar, column etc.
Once I specified the appropriate member type I was able to calculate in steel design.

Regards
Steve

Steven Gregan Ing Civil, MSc.

Ingeniero de Proyectos

[http://www.prdw.com/sites/default/files/prdw.jpg]



Alonso de C?rdova 5900 Piso 10, Las Condes, Santiago, Chile
CP 7560830
T: + 56 2 2694 2000 | sgregan@prdw-av.com | www.prdw.com
Correo sujeto a la renuncia de responsabilidad de PRDW. Ver en: www.prdw.com/disclaimer.html