Robot Structural Analysis Forum
Welcome to Autodesk’s Robot Structural Analysis Forums. Share your knowledge, ask questions, and explore popular Robot Structural Analysis topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Reply
Message 1 of 3
faisal.aaouatif
267 Views, 2 Replies

Loads diplay

Is there anyway to avoid this type of loads display ( beside using uniform planr contour ) ?

Thank you

2 REPLIES 2
Message 2 of 3

It is like that if you use any 3dloads

So in case of contour loads please do not use Automatic Panel Selection...

 

3dl.jpg



Rafal Gaweda
Message 3 of 3
Rafal.Gaweda
in reply to: Rafal.Gaweda

In case of having linear 2p loads in model you may convert them onto linear loads on egdes using attached macro.

(if this 2p load is not defined on real panel edge please remesh panel(s) after conversion)



Rafal Gaweda

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report