Robot Structural Analysis Forum
Welcome to Autodesk’s Robot Structural Analysis Forums. Share your knowledge, ask questions, and explore popular Robot Structural Analysis topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Load to mass problem

2 REPLIES 2
SOLVED
Reply
Message 1 of 3
sedefass
360 Views, 2 Replies

Load to mass problem

Hi, 

When I try to convert load to mass, the program converts the loads that are applied on bars only, not those on shell elements.

2 REPLIES 2
Message 2 of 3
Artur.Kosakowski
in reply to: sedefass

Create a new load case where you have only loads applied to shells. Run static analysis of this case and check that the load is applied correctly. Then in the modal analysis mark disregard density and convert only the new load case to mass. Run calculations and check the total mass in the results of modal analysis case. If it is 0 then send us this model.



Artur Kosakowski
Message 3 of 3
sedefass
in reply to: Artur.Kosakowski

Thank you Artur!

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report