Discussion Groups

Robot Structural Analysis

Mentor
Posts: 183
Registered: ‎12-06-2011

255 Views, 4 Replies
02-06-2013 06:02 AM

Hi

Is it possible to display

1.  the reactions from floors on their supporting beams.

Or

2.  the loading applied to a beam from the floor being supported

Product Support
Posts: 4,544
Registered: ‎12-17-2010

Re: Floor loads on supporting beams

02-06-2013 06:06 AM in reply to: stroxy

Is it possible to display

1.  the reactions from floors on their supporting beams.

Only if you replace them with (elastic) supports.

2.  the loading applied to a beam from the floor being supported

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.

Artur Kosakowski
Mentor
Posts: 183
Registered: ‎12-06-2011

Re: Floor loads on supporting beams

02-07-2013 01:25 AM in reply to: stroxy

Add to wishlist??  It would be great if it was oncorporated in the calculation note for the beam!!

Product Support
Posts: 4,544
Registered: ‎12-17-2010

Re: Floor loads on supporting beams

02-07-2013 01:33 AM in reply to: stroxy

This is the kind of analysis CBS uses for its 1st calculation method. The 'deflection' of  a beam in Robot being FEM type program (assuming you mesh panels rather than use claddings) depends on the overall stiffness of the structure rather than on a load distribution. This would require 'calculations' of loads based on actual deformation of  a beam.

Artur Kosakowski
Distinguished Contributor
Posts: 198
Registered: ‎01-12-2013

Re: Floor loads on supporting beams

02-07-2013 04:50 AM in reply to: Artur.Kosakowski

Wrong:

You can overcome this by integrating supporting beam Fz force diagram:

Fz'(x) = -q(x)

q(x) = -∫Fz(x)dx

but it's too complicated for normal work.

Correct:

You can overcome this by derivating supporting beam Fz force diagram:

Fz'(x) = -q(x)

Fz(x) = -∫q(x)dx

but it's too complicated for normal work.

I'm sorry, typo.

Mirko Jurcevic M.Eng.
INTELIKA d.o.o.
www.intelika.hr