Floor loads on supporting beams

[stroxy]

Hi

Is it possible to display

1.  the reactions from floors on their supporting beams.

Or

2.  the loading applied to a beam from the floor being supported

[Artur.Kosakowski]

---

Is it possible to display

1.  the reactions from floors on their supporting beams.

Only if you replace them with (elastic) supports.

2.  the loading applied to a beam from the floor being supported

Only if you use cladding load distribution

---

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.

[stroxy]

Add to wishlist??  It would be great if it was oncorporated in the calculation note for the beam!!

[Artur.Kosakowski]

This is the kind of analysis CBS uses for its 1st calculation method. The 'deflection' of  a beam in Robot being FEM type program (assuming you mesh panels rather than use claddings) depends on the overall stiffness of the structure rather than on a load distribution. This would require 'calculations' of loads based on actual deformation of  a beam.

[Mirko.Jurcevic]

Wrong:

You can overcome this by integrating supporting beam Fz force diagram:

Fz'(x) = -q(x)

q(x) = -∫Fz(x)dx

but it's too complicated for normal work.

Correct:

You can overcome this by derivating supporting beam Fz force diagram:

Fz'(x) = -q(x)

Fz(x) = -∫q(x)dx

but it's too complicated for normal work.

I'm sorry, typo.