Crash when opening Load Table or entering Loads module

[thomaslade]

Hi All,

RSAP 2013 has suddenly begun to chrash when ever i open the Load Table or try to enter the Loads module. It worked fine one hour and the next i suddenly just didn't. This annoying problem occured first time in the middle of session where i was modelling af slab. First i thougt that maybe my project file was corrupted, but this is not the case since it works fine on other workstations. So I thougt oh it must be a graphicsrelated problem, this was tested by the IT-department that supports the machines, they did not find anything. Then I asked them to uninstall and reinstall RSAP, again without any luck. The problem persists.

I have tried:

- Updating Graphicscard  drivers (Nvidia Quadro K2000M)

- Reinstalling RSAP 2013

- Removing Hardware acceleration

- Deleting windows %Temp%

I have no Idea what to do next. Any help?

Thomas Lade

Structual Engineer

[Rafal.Gaweda · Accepted solution]

Try:

- delete   cfgusr     folder before next robot start

- set any pdf writer as default printer in windows system

[thomaslade]

Did both at once - It worked!

Thanks!