Discussion Groups

Robot Structural Analysis

Reply
Member
C.MacNicol
Posts: 4
Registered: ‎02-06-2013

Core Wall Results - Centre of Rigidity Converges on 0,0,0

240 Views, 4 Replies
03-26-2013 03:17 AM

Hello,

 

Please see the attached images for my problem. I have defined 6 separate corewall. When I view the results it appears there is an error in the value for the top 'cut' i.e. storey 11, cut 2 that comes out much larger than the lower values.

 

When I view the results graphically it shows the centre of rigidity for all the cores converging on point 0,0,0.

 

What could be the cause of this?

 

Regards

 

Chris

Please use plain text.
Product Support
Rafal.Gaweda
Posts: 4,938
Registered: ‎04-26-2010

Re: Core Wall Results - Centre of Rigidity Converges on 0,0,0

03-26-2013 03:26 AM in reply to: C.MacNicol

File please.



Rafal Gaweda
Please use plain text.
Member
C.MacNicol
Posts: 4
Registered: ‎02-06-2013

Re: Core Wall Results - Centre of Rigidity Converges on 0,0,0

03-26-2013 03:35 AM in reply to: C.MacNicol

Is it possible to send this file in a private message? I am setting up a Wetransfer location.

Please use plain text.
Product Support
Rafal.Gaweda
Posts: 4,938
Registered: ‎04-26-2010

Re: Core Wall Results - Centre of Rigidity Converges on 0,0,0

03-26-2013 03:52 AM in reply to: C.MacNicol

Yes, please



Rafal Gaweda
Please use plain text.
Product Support
Rafal.Gaweda
Posts: 4,938
Registered: ‎04-26-2010

Re: Core Wall Results - Centre of Rigidity Converges on 0,0,0

03-27-2013 06:44 AM in reply to: Rafal.Gaweda

It seems there might be some inaccuracies in panels \ stories definition.

I have defined stories from scratch and corrected geometry of panel 168 using addin from http://forums.autodesk.com/t5/Autodesk-Robot-Structural/Rounding-up-coordinates-API/td-p/3430533/pag...  message 16

Still 2 cores ....

2cores.jpg

File in PM.





Rafal Gaweda
Please use plain text.