When using the "Section definition" module , is there any mean to compute the tortional center of a section (group of walls for ex).
Please find attached a calculation note of a typical section of stairwell / lift... (without the information ime looking for )
Thank you
Solved! Go to Solution.
Solved by Pawel.Pulak. Go to Solution.
Torsion&shear center is calculated only when all segments (walls) are connected -see below:
Probably your walls are separated in points where you change their thickness.
---------------------------------------------
If this post answer your question please click "Accept as Solution". It will help everyone to find answer more quickly!
Regards,