Revit MEP

Valued Mentor
Posts: 326
Registered: ‎08-05-2012
Message 1 of 3 (115 Views)
Accepted Solution

connect warning

115 Views, 2 Replies
01-11-2014 10:45 AM




When I connect the power to the water heater The following warning is displayed.What settings should I do?




*Expert Elite*
Posts: 2,926
Registered: ‎08-28-2009
Message 2 of 3 (82 Views)

Re: connect warning

01-13-2014 08:19 AM in reply to: gh_ar

It appears that you are trying to connect a 1-pole or 3-pole piece of equipment to a 2-pole Electrical Circuit. If the equipment is intended to be 2-pole, then check the element's Properties and Type Properties for a parameter that controls the Number of Poles. If you cannot find one, you will have to open the Family for editing and select the Electrical Connector to see what the Number of Poles is set to.

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Valued Mentor
Posts: 326
Registered: ‎08-05-2012
Message 3 of 3 (78 Views)

Re: connect warning

01-13-2014 08:50 AM in reply to: CADastrophe

Hi CADastrophe


Thank you.

You are right  .

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Revit Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Revit helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Revit