Revit MEP

New Member
Posts: 1
Registered: ‎08-20-2007
Message 1 of 2 (908 Views)
Accepted Solution

Revit MEP - Reducing Tee Generic

908 Views, 1 Replies
08-20-2012 02:28 PM



I realize that there have been many posts about the lack of a generic reducing tee for copper pipe. I have made many piping models and as all of you well know, tees are created as standard tees then with reducers to change pipe sizes. After doing some research on other fittings, it appears that I must create my own parameters and look-up tables to create a simple reducing tee. Is this accurate or did I miss something? Any suggestion, solutions of content would be greatly appreciated.


Phil G

Product Support
Posts: 591
Registered: ‎09-08-2010
Message 2 of 2 (858 Views)

Re: Revit MEP - Reducing Tee Generic

08-22-2012 10:59 AM in reply to: pgauntt

Here's a link that will help you. Look at the last response in the thread


I also suggest that you post leaving feedback at the below link. Information gathered is used to improve the application.


Product Contact Link:


Thanks for posting.

Alan Quinn
Support Specialist
Product Support
Autodesk, Inc.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Revit Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Revit helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Revit