Revit MEP

Posts: 372
Registered: ‎01-09-2004
Message 1 of 2 (193 Views)

RMEP 2011 - no 'Pipe Sizing' tool when a sanitary pipe is selected

193 Views, 1 Replies
09-26-2012 08:37 AM

I'm using RMEP 2011. When I select a sanitary pipe (or highlight an entire sanitary run), there is no 'Pipe Sizing Tool' in the Ribbon like there is when I select CW or other supply pipe. Is Sanitary pipe sizing support in RMEP 2011? If so, any suggestions as to where should I start looking for the problem?



Striving to be a WOMBAT, Waste Of Money, Brains, & Talent...

⁞|⁞ Please use the Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos functions as appropriate to further enhance the value of these forums. Thank you!
Valued Mentor
Posts: 457
Registered: ‎06-16-2010
Message 2 of 2 (181 Views)

Re: RMEP 2011 - no 'Pipe Sizing' tool when a sanitary pipe is selected

09-26-2012 10:33 AM in reply to: dtiemeyer

It is not supported - probably due to using the UPC or IPC for fixture units, etc.. Sanitary systems will however add up the fixture units so a manual sizing can be done.

If my reply answers your query, please use the Accept as Solution.
Please give Kudos as appropriate to enhance the value of these forums.

Thank you!

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Revit Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Revit helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Revit