Revit MEP

Reply
Valued Contributor
N_nmulder
Posts: 52
Registered: ‎12-27-2007
Message 1 of 2 (187 Views)

Pipe drop symbol not trimming inner pipe at specific elevations

187 Views, 1 Replies
03-10-2014 01:07 PM

I cannot find the solution to my little problem. Having used Revit extensively for the last 3 years I am surprised I have not had this problem before...or I have forgotten how to solve it.

 

Refer to attached images. View detail is coarse or single line. Piping is at 9'. Elbow or tee of other pipe is at 9' 7". The drop symbol does not 'trim' the lower/inner pipe at 9'. This happens 9'7" down to 9'4" (lowest acceptable height with room for fittings). However, if I raise the other pipe to 9'8" or higher it displays correctly. The inner/lower 9' pipe is trimmed out of the drop symbol.

 

What am I missing?  

Valued Contributor
ajax05k
Posts: 59
Registered: ‎01-12-2014
Message 2 of 2 (148 Views)

Re: Pipe drop symbol not trimming inner pipe at specific elevations

03-11-2014 05:20 AM in reply to: N_nmulder

The only Solutions i can think of are
1. Increase the offset of the top pipe[ obviously no need for me to tell, but then...]
2. Try using the 30 degree elbow.
3. Create a new filter of pipe fittings and hide those particular elbows [by giving type mark] which produces these type of problems.

Ajay K. HVAC Designer, BIM Modeler

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Revit Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Revit helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Revit

Twitter

Facebook

Blogs

Youtube