Revit MEP Forum
Welcome to Autodesk’s Revit MEP Forums. Share your knowledge, ask questions, and explore popular Revit MEP topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Pipe Justification Problem

4 REPLIES 4
Reply
Message 1 of 5
blamb97
625 Views, 4 Replies

Pipe Justification Problem

i'm running REVIT MEP 2013, and out ot the box i've been having this problem with the generic pipe transition..

 

Offset.PNG

 

but when i click on the justify tab for both pipes, and even the fitting, they all show center justify..

 

Justify.PNG

 

is there another family i should be using, or is there a justification setting that i don't know about that could help.

 

thanks.

 

4 REPLIES 4
Message 2 of 5
Ossey
in reply to: blamb97

I am experiencing the same problem. Can anyone help? In addition, using the generic sizes, elbows and T's and othe jointing connections don't change size when a new layout is drawn with a new piping diameter

Message 3 of 5
blamb97
in reply to: blamb97

i was attempting to use a specific pipe type, the only way that i was able to get the transition to show corretly was to change the type to "standard".  it doesn't necessarily fix the problem, but it was a work around that allowed me to move forward for the deadline.

Message 4 of 5
CoreyDaun
in reply to: blamb97

Try deleting the transition and then set the justification the Justification of the Pipes. Then reconnect them using the Trim/Extend command.

I don't believe that changing the Justification of existing elements has a "correcting" effect.

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Message 5 of 5
blamb97
in reply to: CoreyDaun

thanks, i did try that, and i tried to illustrate that in the second screen capture.  all the justifications were center, before, and after the incorrect transition was created.  not until i changed the pipe type to a generic, versus the specific did it create the correct transitions.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Rail Community


Autodesk Design & Make Report