Revit MEP

Reply
Member
blamb97
Posts: 3
Registered: ‎11-07-2012
Message 1 of 5 (279 Views)

Pipe Justification Problem

279 Views, 4 Replies
11-07-2012 05:21 AM

i'm running REVIT MEP 2013, and out ot the box i've been having this problem with the generic pipe transition..

 

Offset.PNG

 

but when i click on the justify tab for both pipes, and even the fitting, they all show center justify..

 

Justify.PNG

 

is there another family i should be using, or is there a justification setting that i don't know about that could help.

 

thanks.

 

New Member
Ossey
Posts: 2
Registered: ‎10-10-2012
Message 2 of 5 (242 Views)

Re: Pipe Justification Problem

11-12-2012 11:18 AM in reply to: blamb97

I am experiencing the same problem. Can anyone help? In addition, using the generic sizes, elbows and T's and othe jointing connections don't change size when a new layout is drawn with a new piping diameter

Member
blamb97
Posts: 3
Registered: ‎11-07-2012
Message 3 of 5 (239 Views)

Re: Pipe Justification Problem

11-12-2012 11:26 AM in reply to: blamb97

i was attempting to use a specific pipe type, the only way that i was able to get the transition to show corretly was to change the type to "standard".  it doesn't necessarily fix the problem, but it was a work around that allowed me to move forward for the deadline.

*Expert Elite*
CADastrophe
Posts: 3,163
Registered: ‎08-28-2009
Message 4 of 5 (236 Views)

Re: Pipe Justification Problem

11-12-2012 11:33 AM in reply to: blamb97

Try deleting the transition and then set the justification the Justification of the Pipes. Then reconnect them using the Trim/Extend command.

I don't believe that changing the Justification of existing elements has a "correcting" effect.

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Member
blamb97
Posts: 3
Registered: ‎11-07-2012
Message 5 of 5 (230 Views)

Re: Pipe Justification Problem

11-12-2012 12:32 PM in reply to: CADastrophe

thanks, i did try that, and i tried to illustrate that in the second screen capture.  all the justifications were center, before, and after the incorrect transition was created.  not until i changed the pipe type to a generic, versus the specific did it create the correct transitions.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Revit Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Revit helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Revit

Twitter

Facebook

Blogs

Youtube