Guys I have attached a floor box when placed on a floor you would thing the top lip would be flush with the floor but it appears the bottom of the box is where it inserts. Can you tell me how I can change that point and drop it down 6.5"?
Looks like you'll have to do it extrusion-by-extrusion in an Elevation View to get them down to the Reference Level. It doesn't look like anything is constrained to your Reference Planes, so you can just re-create them if you need them. As for the extrusions, start with the bottom. For the basic extrusions, start by removing any constraints and then modify the "Extrusion End" and "Extrusion Start" as needed. You can easily do this with the complicated fractional values by typing a "=" before the value and then '-6.5" ' after it to create a formula. As for the revolves, you should be able to just move them after removing any constraints.
Another possibility would be to load this family into a new host family. There, you could create a Reference Plane 6.5" below the Reference Level (in an elevation View), designate that as the Work Plane, and then place an instance of your family in the Ref. Level View.
Corey D. ────────────────────────────────────────────────────────────────────── ⁞|⁞ Please use .Accept as Solution and Give Kudos as appropriate to further enhance these forums. Thank you!