Revit MEP

Reply
Active Member
chrissumner
Posts: 10
Registered: ‎04-11-2011
Message 1 of 3 (1,400 Views)
Accepted Solution

Change pipe line type with invert level

1400 Views, 2 Replies
07-30-2012 07:41 AM

Ive been told i can use filters to change a pipes linetype by invert level but cant figure out how it works. I'd like to set up a filter so pipes shown below the floor are hidden (below level 0), at low level (from level 0 to 2400) are solid and at high level(from 2400-slab) are a centre line. I know there's an overhead linetype but its too similar to the hidden.

 

Ive looked through the filters and cant see an option to filter by invert level?

 

Any help appreciated.

 

Thanks

 

Active Contributor
gookeeper
Posts: 44
Registered: ‎02-09-2005
Message 2 of 3 (1,386 Views)

Re: Change pipe line type with invert level

07-31-2012 03:44 PM in reply to: chrissumner

I Chrissumer

 

i hope the images explain what you need to know. think its invert elevation your after.

 

Cheers

 

Guy

Active Member
chrissumner
Posts: 10
Registered: ‎04-11-2011
Message 3 of 3 (1,362 Views)

Re: Change pipe line type with invert level

08-01-2012 01:04 AM in reply to: gookeeper

 

Thankyou for taking the time to provide screenshots, the solutions works 100%

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.