Community
In assigning the Distribution System to a piece of Electrical Equipment, there is a nice, convenient pull-down on the upper bar. When a Transformer is selected, however, one must go into the Element's Properties to find the Secondary Distribution Parameter to assign a system to it. It doesn't seem unreasonable to request that a similar pull-down be supplied when a Transformer is selected. I can't see this as being terribly difficult to add to the program. See image below for an illustration of what I'm talking about.
Corey D. 
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use
.Accept as Solution and 
Give Kudos as appropriate to further enhance these forums. Thank you!
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use
.Accept as Solution and Give Kudos as appropriate to further enhance these forums. Thank you!
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")