Revit MEP Wishes

Reply
Active Contributor
msoren
Posts: 46
Registered: ‎12-10-2007
Message 1 of 2 (97 Views)

Offsets

97 Views, 1 Replies
01-16-2008 03:40 PM
It would be really helpful if the offset could be associated with the top, middle or bottom of duct and pipe.
New Member
d.smith
Posts: 2
Registered: ‎06-22-2010
Message 2 of 2 (76 Views)

Re: Offsets

08-31-2011 11:46 AM in reply to: msoren

It would also be nice if you could set the Pipe Offset to be to Center, Top of Outside (Including Insulation), Top of Outside, Top of Inside, Bottom of Outside (Including Insulation), Bottom of Outside, & Bottom of Inside.  Right now, the orientation only allows for top of Inside Diameter, Bottom of Inside Diameter, and Center, and the "Offset" always goes to the center of pipe regardless of the alignment. In addition to the insulation for piping and ducting, the lining also needs to be accounted for when refering to ducting.

 

This would be a HUGE workflow benefit and needs to be a priority one item!!!

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community