Revit MEP Wishes

Active Contributor
Posts: 30
Registered: ‎03-30-2007
Message 1 of 2 (51 Views)

Conical Ductwork taps

51 Views, 1 Replies
04-02-2007 12:31 PM
I wish the conical ductwork tap that comes with Revit would function properly. The standard ductwork tap for round ductwork works just fine, but I get an error when I try to create a conical fitting.
Posts: 23
Registered: ‎06-13-2003
Message 2 of 2 (51 Views)

Re: Conical Ductwork taps

11-13-2007 11:21 PM in reply to: elliot.millican
Can you just make your own from the standard duct tap?

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community