Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I have a framing plan that some walls will show up as simple 2 line walls in plan view and some that show up with poche and heavy outline. My question is why do they show up differently in the same plan when everything about them is identical. Height, constraints, offsets etc. I have discipline set to coordination. Any help would be appreciated.
Under "Structural Usage" in the wall properties are some set to bearing
vs non-bearing?
Robert Witte
john fleming wrote:
> I have a framing plan that some walls will show up as simple 2 line walls in plan view and some that show up with poche and heavy outline. My question is why do they show up differently in the same plan when everything about them is identical. Height, constraints, offsets etc. I have discipline set to coordination. Any help would be appreciated.
>
> John Fleming
Problem was that the walls were not stopping at the bottom of the floor. Also, couldnt post flie because the smallest that I could make it was 3.2mb. There were only 8 walls and 1 floor. Seems a lttle large to me but the full file is 40mb. 2 Storey house with basement. Is this typical?
