Revit Architecture

Reply
Distinguished Contributor
Posts: 175
Registered: ‎01-11-2007
Message 1 of 4 (245 Views)
Accepted Solution

Wall Family with variable interior finishes

245 Views, 3 Replies
06-24-2011 10:45 AM

I am working on a project that has an exterior wall of concrete block.  The interior of the building will be finishes with furring and gypsum board.  However, there are certain areas of the wall that will not have an interior finish (the location of the stairs and elevator - they are located against the exterior wall).

 

What is the best way of doing this?  I would assume two wall families - one with the finish and one without.  Then join the geometry...

 

Anyone come across this type of situation and how to approach it?

 

Thanks in advance

 

-Dave

*Expert Elite*
Posts: 788
Registered: ‎04-08-2008
Message 2 of 4 (224 Views)

Re: Wall Family with variable interior finishes

06-25-2011 06:38 AM in reply to: dtdesign

There are two ways you can do it:

 

1st: the way you mentioned, which is the way I'd recommend.  You don't even have to manually join the geometry, the walls will join automatically.

 

2nd: Make two separate wall types (one for the CMU, one for the furring).  This can be useful in several cases.  For example, if your furring isn't always going to be the same depth (7/8" hat channels vs. 3-5/8" studs, for example), then you should go with the CMU and furring wall types.  Also, if you're doing a renovation project, and you want to strip down the wall to the structural layer by removing just the finish layer, then two walls is the way to go.  Just remember that with this method, you'll need to manually Join the two walls together so that doors and windows inserted into one wall also cut the parallel wall.

Ross Kirby
BIM Manager
Arcturis
Distinguished Contributor
Posts: 175
Registered: ‎01-11-2007
Message 3 of 4 (220 Views)

Re: Wall Family with variable interior finishes

06-25-2011 07:00 AM in reply to: rosskirby

Thanks so much for this information.  My major issue is that the CMU walls are exterior and three stories high - so the middle level is the one with the finished interior walls (some aren't due to the stairs and elevators being up against the exterior walls).  So, I wanted the exterior CMU to go from grade to parapet and provide just the furring on the center level of offices.

 

Your suggestions definitely fit the bill...

New Member
francisco
Posts: 1
Registered: ‎05-09-2011
Message 4 of 4 (214 Views)

Re: Wall Family with variable interior finishes

06-25-2011 08:16 AM in reply to: dtdesign

Stacked wall is another alternative. . . adjust the elevation of the particular occurrences.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Revit Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Revit helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Revit

Twitter

Facebook

Blogs

Youtube