Revit Architecture

New Member
Posts: 1
Registered: ‎07-15-2011
Message 1 of 2 (357 Views)

Problem: visibility of a beam in plan view

357 Views, 1 Replies
07-15-2011 02:08 AM

If i draw a beam in plan view en define the height, the beam disepare. Is there a posibility that the beam is in place and you can see a dash dot line and two dashed lines in plan view?



Posts: 25
Registered: ‎06-05-2008
Message 2 of 2 (328 Views)

Re: Problem: visibility of a beam in plan view

07-17-2011 02:18 PM in reply to: t_deferme

Most likely the beam level is above the view cut plane level. If you put in a plan region where the beam is located ( View tab / plan views / plan region ) and set this cut level to be through the beam, you can then see the beam.  You can then use the linework tool to get a dash dot line or however you would like it to display.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Revit Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Revit helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Revit