Revit Architecture

Reply
Active Member
Posts: 8
Registered: ‎07-12-2004
Message 1 of 2 (73 Views)

Joining Solids - created in place

73 Views, 1 Replies
09-17-2004 08:35 AM
I have created three solids representing a fireplace surround.

How can I join these three items? Trim? Join geometry?

Not sure if this is possible without creating a sweep. However creating a sweep vertically doesn't seem possible.

Help.
*JTB
Message 2 of 2 (73 Views)

Re: Joining Solids - created in place

09-17-2004 09:15 AM in reply to: Scott Foss
You will see my post about sweep problems... I guess the best way to do such things is in-place families. Then you can use join geometry. Before you experiment with those, wait for more answers, because I am new to Revit too! :-)) Ï "Scott Foss" Ýãñáøå óôï ìÞíõìá news:4814457.1095435365086.JavaMail.jive@jiveforum1.autodesk.com... > I have created three solids representing a fireplace surround. > > How can I join these three items? Trim? Join geometry? > > Not sure if this is possible without creating a sweep. However creating a sweep vertically doesn't seem possible. > > Help.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Revit Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Revit helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Revit

Twitter

Facebook

Blogs

Youtube