Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I would like to resolve the corner of these two intersecting boards. I would like to cut out the exsising geometry that over laps on the other side of the board and end up with approx. 45 degree meeting angle. I have attached the file to this post. Anything can help.
Should I start over and construct each individual piece of wood differently? Or is there a way to essentiall do a 3d Trim to make the corner even?
