Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I have placed wood beams and I-Joist on a floor plan. I can see both. I some cases (very few) I can extend the I-Joist over the beam to the far side face of the beam which is what I need to do. However, in most cases the I-Joist either extends or trims to the near face, which means the I-Joist is "floating and not sitting on the beam or the I-Joist extends or trims to the center line of the beam.
When you select the beam check in the properties and there is a place where you can enter "start extension" or "end extension". This will extend either end of the beam as far as you want.
