Revit Architecture

Reply
Member
PSBrown
Posts: 4
Registered: ‎12-29-2011
Message 1 of 3 (888 Views)
Accepted Solution

Base Extension Property

888 Views, 2 Replies
08-22-2012 09:50 AM

On a simple exterior wood frame wall type, I can't seem to figure out how to activate the base extension property; it is greyed out. How do I activate this parameter so I can extend the exterior sheathing of the wall past (below) the rim joist?

 

Employee
loboarch
Posts: 978
Registered: ‎09-05-2003
Message 2 of 3 (876 Views)

Re: Base Extension Property

08-22-2012 11:36 AM in reply to: PSBrown

You need to unloack the layers of the wall you wan tto extend.  In the type properties dialog, edit the structure of the wall.  Click "Modify" in the lower section of the editing dialog.  Then you can click on the edge in the wall preview and "unlock" the wall layers.  Once you do this the base extension property for the wall will no longer be gray.

 

unlock_layers.png



Jeff Hanson
Sr. Subject Matter Expert
Autodesk, Revit User Experience
Member
PSBrown
Posts: 4
Registered: ‎12-29-2011
Message 3 of 3 (860 Views)

Re: Base Extension Property

08-22-2012 02:44 PM in reply to: loboarch

Thanks Jeff. Much help. Now I have a similar question with a roof. I'll post a new thread.

PB

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.