QuickCAD

Reply
*Smith, Harvey
Message 1 of 1 (11 Views)

Does QC7 have "extend"?

11 Views, 0 Replies
03-26-2000 11:57 AM
Hiya, Dave,

Try the TrimCorner or TrimEdge tools. That usually does it, unless you have some
special circumstance.

If you have time, go over to the AutoSketch newsgroup, and back on 2/28/00 there
was a post called "AutoSketch 7.0 - Line Extension" from Chris Buck. There was a
good deal of discussion about this line extension business. I suspect everything
possible about this issue was discussed for AS R7. More than likely for QC R7,
too.

H

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community