Quantity Takeoff

Reply
ben
New Member
ben
Posts: 1
Registered: ‎12-30-2012
Message 1 of 1 (505 Views)

categorising and separating similar items in QTO?

505 Views, 0 Replies
12-30-2012 10:13 AM

Im using QTO with a model for automatic take off, and trying to find a way of differentiating between a flat plasterboard ceiling which should be meaured as an area, and a strip of plasterboard which should be measured as a liner measurement.

 

At the moment all i can seem to get is all platerboard ceiling as an area, so my question is can I get QTO to look at an item and if the width is less than a certain amount meaure it as a length, and if it is greater than this amount then measure it as an area? also is it possible to differentiate between vertical and horizontal items?

 

many thanks

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community