Quantity Takeoff (Read Only)
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

categorising and separating similar items in QTO?

0 REPLIES 0
Reply
Message 1 of 1
ben
Community Visitor
937 Views, 0 Replies

categorising and separating similar items in QTO?

Im using QTO with a model for automatic take off, and trying to find a way of differentiating between a flat plasterboard ceiling which should be meaured as an area, and a strip of plasterboard which should be measured as a liner measurement.

 

At the moment all i can seem to get is all platerboard ceiling as an area, so my question is can I get QTO to look at an item and if the width is less than a certain amount meaure it as a length, and if it is greater than this amount then measure it as an area? also is it possible to differentiate between vertical and horizontal items?

 

many thanks

0 REPLIES 0

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report