Printing and Plotting

Reply
Distinguished Contributor
bruceclement
Posts: 182
Registered: ‎11-24-2003
Message 1 of 2 (425 Views)

Publish vs Plot - image shifts, border cut off

425 Views, 1 Replies
08-13-2012 04:41 PM

I have found that when I Publish, the drawing comes out shifted about 1/8" down and 1/8" left as compared to when I use Plot. Which of course is just enough to cut off the sheet border which is 1/2" from the paper edge. I am using the same Page Setup for both Publish and Plot, same drawing.

 

This is to an Oce TDS600, and it only happens with 15x21 paper size. All paper sizes are set to 0" border. Probably an Oce issue, but have any of you seen this before?

 

Thanks.

Distinguished Contributor
cascadtx
Posts: 146
Registered: ‎09-02-2003
Message 2 of 2 (328 Views)

Re: Publish vs Plot - image shifts, border cut off

09-13-2012 07:36 AM in reply to: bruceclement

I am having much bigger shift/orientation issues with an Oce 860 and a KIP 3000 using the PostScript drivers.  I believe it is an AutoCAD problem because EVERY OTHER application that prints to these DOES NOT have the problem.  I have plotted to a file then opened the PS file using GSVIew so I can see the output without printing to paper.  The problem is definitely in the PostScript output.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community