Printing and Plotting

Reply
Contributor
bobcad2009
Posts: 12
Registered: ‎03-22-2009
Message 1 of 3 (429 Views)
Accepted Solution

Plot selected area

429 Views, 2 Replies
10-30-2011 01:18 PM

Hello ,

I have a question , if i want to plot from a DWG file on a diferent angle it is possible? , like in the attachement.

 

Thank you

*Expert Elite*
M_Hensley
Posts: 1,676
Registered: ‎12-11-2003
Message 2 of 3 (419 Views)

Re: Plot selected area

10-31-2011 04:36 AM in reply to: bobcad2009

You just need to adjust your user coordinate system.

 

Type UCS then 3 and select 3 of the corners of your rectangle.

Now type plan and current and the drawing will turn to make your angled rectangle square to the screen.

 

Plot your area then switch the UCS back to world and plan command again to get the drawing back to normal.

Contributor
bobcad2009
Posts: 12
Registered: ‎03-22-2009
Message 3 of 3 (410 Views)

Re: Plot selected area

10-31-2011 01:05 PM in reply to: M_Hensley

Thank you Hensley!!!!! I made:smileywink:

 

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community