Printing and Plotting

Reply
Member
vreeling
Posts: 3
Registered: ‎06-09-2011
Message 1 of 2 (170 Views)

Error: Did not plot

170 Views, 1 Replies
06-09-2011 04:38 AM

Hello,

 

We use Autocad LT2012 en we have a problem when we want to plot.

1 drawing goes fine, but when we take multiple drawing, we get an error.

 

Job: - error(s)  Did not plot

Job ID:21

Date and time....

 

Sheet : 2011-03-21..... - Error(s) dit not plot

 

File: (location of drawing)

Catergory name:

Page setup:

Device name:

Plot file path:

Paper size:

 

Error: drawing not found.

 

The location of de drawing is correct.

 

I included the error message....

 

Can anybody please help me.

It's not easy when u have to plot 1 drawing at a tim....

 

*Expert Elite*
tcorey
Posts: 2,314
Registered: ‎12-18-2002
Message 2 of 2 (149 Views)

Re: Error: Did not plot

06-16-2011 04:33 PM in reply to: vreeling

Your path names are awfully long. If you were to more that to a folder with a short name, do you get better results?

Tim Corey, Owner
Delta Engineering Systems
Redding, CA
Autodesk Authorized Value-Added Reseller

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community