Pointing Devices and Displays

Pointing Devices and Displays

Reply
Contributor
fmichaelsikes
Posts: 11
Registered: ‎06-26-2008
Message 1 of 4 (868 Views)

CROSSHAIRS "JUMPING"

868 Views, 3 Replies
06-22-2010 09:40 AM

DOES ANYONE KNOW HOW TO ADJUST THE CROSSHAIR MOVEMENT

SO IT IS SMOOTH INSTEAD OF JUMPING?

Contributor
maximo916
Posts: 20
Registered: ‎03-05-2009
Message 2 of 4 (851 Views)

Re: CROSSHAIRS "JUMPING"

07-14-2010 09:01 AM in reply to: fmichaelsikes

Turn SNAP off.

In the command prompt....SNAP>Enter>OFF

 

I've found that anytime I do DVIEW, Snap turns itself on. Not sure why.

Active Contributor
rmitchler
Posts: 33
Registered: ‎01-08-2008
Message 3 of 4 (634 Views)

Re: CROSSHAIRS "JUMPING"

12-16-2010 02:21 PM in reply to: fmichaelsikes

To add to that turn your grid off it also causes the jump between grid spacing.

 

Robert

New Member
texankevin
Posts: 1
Registered: ‎12-08-2010
Message 4 of 4 (450 Views)

Re: CROSSHAIRS "JUMPING"

03-14-2011 12:52 PM in reply to: fmichaelsikes
check your grid snaps, you can turn them off or change to snap size. Really unless you are working with Architechure you dont really even need to use grid snaps. good luck
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.