Pointing-Devices and Displays

Reply
Contributor
Posts: 11
Registered: ‎06-26-2008
Message 1 of 4 (846 Views)

CROSSHAIRS "JUMPING"

846 Views, 3 Replies
06-22-2010 09:40 AM

DOES ANYONE KNOW HOW TO ADJUST THE CROSSHAIR MOVEMENT

SO IT IS SMOOTH INSTEAD OF JUMPING?

Contributor
Posts: 20
Registered: ‎03-05-2009
Message 2 of 4 (829 Views)

Re: CROSSHAIRS "JUMPING"

07-14-2010 09:01 AM in reply to: fmichaelsikes

Turn SNAP off.

In the command prompt....SNAP>Enter>OFF

 

I've found that anytime I do DVIEW, Snap turns itself on. Not sure why.

Active Contributor
Posts: 33
Registered: ‎01-08-2008
Message 3 of 4 (612 Views)

Re: CROSSHAIRS "JUMPING"

12-16-2010 02:21 PM in reply to: fmichaelsikes

To add to that turn your grid off it also causes the jump between grid spacing.

 

Robert

New Member
texankevin
Posts: 1
Registered: ‎12-08-2010
Message 4 of 4 (428 Views)

Re: CROSSHAIRS "JUMPING"

03-14-2011 12:52 PM in reply to: fmichaelsikes
check your grid snaps, you can turn them off or change to snap size. Really unless you are working with Architechure you dont really even need to use grid snaps. good luck

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community