Is there a setting that will disable navisworks from creating a new 3D view in revit everytime the switchback function is used? I would rather have a 3d view configured with the setting I want and have navisworks switch to that instead of creating a new view each time that needs its settings adjusted. I didn't have to do this when working on a revit 2012 project. I think that work flow is much better that this so called improvement to R2013.
I talked to development about this case. Apparently a code fix is required to address it and no date was given on when we can expect to see the changes. However, I understand it will be sooner rather than later.
Thanks for posting.
I take it sooner never happened. I'm very disappointed in the fact that this feature is pretty useless now that it has been "improved".
Has anyone found a way to work with switchback now that it "must" generate a new view everytime the switchback function is used.
I might try to re-install Navis 2012 where this didn't happen.
I noticed this too. I switches to a rendered perspective view. I never use that. I want it to switch to a plan view in wireframe. This tool is totally useless now.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!