.NET

Reply
Active Contributor
Posts: 45
Registered: ‎11-28-2012
Message 1 of 2 (167 Views)

Tab merge partial cui

167 Views, 1 Replies
04-15-2013 02:34 AM

Hi

 

I have created a partial cui file that creates a new tab and a panel in the tab. This works fine.

 

When I try to create another cui for another plug-in I cannot get the two tabs to merge. I have set the tab Aliases to be the same but they show up as two tabs next to eachother.

 

Any ideas?

ADN Support Specialist
Balaji_Ram
Posts: 610
Registered: ‎03-21-2011
Message 2 of 2 (160 Views)

Re: Tab merge partial cui

04-15-2013 03:14 AM in reply to: Fredrik.Larsen

Hi Fredrik,

 

AutoCAD does not merge tabs from partial CUI.

 

Only tabs in the main cui are considered by AutoCAD for merging based on their alias.

This post might be of some help :

http://forums.autodesk.com/t5/AutoCAD-2011/common-ribbontab-in-different-partial-cui/td-p/3408299

 

 



Balaji
Developer Technical Services
Autodesk Developer Network

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community