.NET

Reply
Active Contributor
C-Hoppen
Posts: 39
Registered: ‎04-25-2002
Message 1 of 2 (102 Views)

Jig - No Single Step Debugging

102 Views, 1 Replies
11-27-2013 04:19 AM

Hello,

 

I tried a lot of sample (mostly from spidernet) using EntityJig. My problem is always the same: I can't walk through "protected  override SamplerStatus Sampler" method by single step debugging. If a Break Point inside this overritten method is reached, a new tab "No source available" is shown and debugging stops.

AutoCAD 2013, Visual Studio 2013, c#

 

Same with protected override bool Update().

 

Any Idea?

 

Thanks, Christoph

Valued Mentor
gasty1001
Posts: 450
Registered: ‎04-11-2010
Message 2 of 2 (92 Views)

Re: Jig - No Single Step Debugging

11-27-2013 05:55 AM in reply to: C-Hoppen

Hi,

 

Did you read this?: Debuggin with VS 2013 , also you can visit this link for more suggestions: No Source and check this extension for VS: Disable No Source Tab


And don't forget to set NEXTFIBERWORLD to 0.

 

Gaston Nunez

 

 

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community