Posts: 4
Registered: ‎06-02-2009
Message 1 of 2 (147 Views)
Accepted Solution

Help with "CreateExtrudedSolid" & "sweepoptions "

147 Views, 1 Replies
04-18-2013 04:28 PM

In the past I used "AddExtrudedSolid" to extrude a region without any problems, worked like a charm see "old" code below.


F3D = AcadDoc.ModelSpace.AddExtrudedSolid(AcadRegion, Math.Abs(CollThickness(x)), 0)


I'm currently updating the code because "AddExtrudedSolid" is now known as "CreateExtrudedSolid". In the new version, my last parameter is asking for a "sweepoptions". Doesn't matter what I put there, it doesn't like it. See the code below. What do I need to do to make it work?


Dim so As SweepOptions
F3D = acSol3D.CreateExtrudedSolid(AcadRegion, Math.Abs(CollThickness(x)), so )


*Expert Elite*
Posts: 1,555
Registered: ‎10-08-2008
Message 2 of 2 (126 Views)

Re: Help with "CreateExtrudedSolid" & "sweepoptions "

04-18-2013 10:23 PM in reply to: wcruzcc
Try this code snip it's working on A2010:
sold.CreateExtrudedSolid(curv, New Vector3d(1, 2, 20), New SweepOptions())
Change vector and curve to your settings

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community