I am using acad 2012, and VS 2010 (C#) on win 7 64 bit.
I made a form, and showing it as modeless via Application.ShowModelessDialog... as recommended by everyone and that works fine.
I have a button that does something, and I set a break point right on the first line of code for its callback.
The button runs fine, but VS is not stopping at the break point.
Is there a different technique required when debugging modeless forms?
thx
internal protected virtual unsafe Human() : mostlyHarmless
I'm just here for the Shelties
Solved! Go to Solution.
Solved by Alfred.NESWADBA. Go to Solution.
Hi,
have you set Framework4 as the current Framework for your project?
If you don't want FW4 then a good point to look at: >>>here<<<
And NEXTFIBERWORLD could be a point-of-interest, look to >>>this issue<<<
- alfred -
yah, setting framework to 4 did the trick.
The other options Kean mentioned are less desirable.
Wish I could stick with 3.5, as 4 is not always on a given machine.
Guess I can switch back before deploying.
Thanks a bunch for your reply, i was worried about this last night.
internal protected virtual unsafe Human() : mostlyHarmless
I'm just here for the Shelties
Hi,
>> Wish I could stick with 3.5, as 4 is not always on a given machine.
If AutoCAD 2012 is installed, then Framework 4 is installed, it does not run without! 😉
- alfred -
I lose track of what needs what. I program for 2009 and 2012 so I will just target each project for correct framework.
thx
internal protected virtual unsafe Human() : mostlyHarmless
I'm just here for the Shelties
Hi,
>> I lose track of what needs what
check the bottom of >>>this link<<<
...and for 2012 you need 4.0
- alfred -