.NET

Reply
New Member
JoKees
Posts: 1
Registered: ‎08-26-2005
Message 1 of 2 (57 Views)

Adding references and auto completion

57 Views, 1 Replies
08-26-2005 08:27 AM
Hi all,

I'm just getting started in .net programming. So I followed the CAD Clinic Going.NET article to get myself a little bit more familiar with this programming thing and #Develop.
As the author explained I referenced both AcdbMgd.dll and AcMgd.dll (from the .NET Assembly browser).

So far, no problem, but fact is that there is no 'auto completion' for both the DLL's (for others there is no problem).

Does anyone run in the same problem, and how can you fix it.
It is quite difficult to program without.

PS. The auto completion table was already created

Thanks
*Mike Tuersley
Message 2 of 2 (57 Views)

Re: Adding references and auto completion

08-26-2005 09:36 AM in reply to: JoKees
There is no auto completion with #Develop - it has something to do with the
Adesk libraries. Check the #Develop news groups as they were looking into
it a while back.

Even without the auto-completion, its still good for a free ide ;-)

-- Mike
___________________________
Mike Tuersley
___________________________
the trick is to realize that there is no spoon...

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community