amthread ..... another problem!

[steveoliver]

ok draw a cube again.... drill a large blind hole on the top face into the cube say 2/3's into it. now on one of the side faces create a workplane draw a circle , profile and constrain it to intersect the 1st hole drilled. extrude (cut) the circle to go through and beyond the 1st hole. now use amthread to add a thread to the first section of the second hole upto where it intersects the 1st hole. i would normally use the dim to the centre hole, but when you do this it threads the entire length of the hole! i presume this too is a bug 🙂

[Anonymous]

Hi Steve,

We are already aware of this and a defect has been
logged against this.

Thanks,

Raj kumar,

Software QA Engineer,

Autodesk,Inc.

style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">

"steveoliver" <
href="mailto:steve.oliver@diverseylever.com">steve.oliver@diverseylever.com>
wrote in message
href="news:f08437c.-1@WebX.maYIadrTaRb">news:f08437c.-1@WebX.maYIadrTaRb...

ok
draw a cube again.... drill a large blind hole on the top face into the cube
say 2/3's into it. now on one of the side faces create a workplane draw a
circle , profile and constrain it to intersect the 1st hole drilled. extrude
(cut) the circle to go through and beyond the 1st hole. now use amthread to
add a thread to the first section of the second hole upto where it intersects
the 1st hole. i would normally use the dim to the centre hole, but when you do
this it threads the entire length of the hole! i presume this too is a bug
:)