Mechanical Desktop

Reply
Valued Contributor
rich
Posts: 79
Registered: ‎09-18-2007
Message 1 of 3 (34 Views)

Raster images

34 Views, 2 Replies
10-09-2007 10:59 AM
I can clip an image and make chamfers on the corners but is there a way I can make fillets?
*Expert Elite*
JDMather
Posts: 26,246
Registered: ‎04-20-2006
Message 2 of 3 (34 Views)

Re: Raster images

10-09-2007 03:05 PM in reply to: rich
You could create a polygon with a high number of sides to simulate an arc.
Then run Image clip - new polygon and select the endpoints of the lines to create a new clipping polygon.
Attached is a quick example. I didn't create very many edges to approximate arc to save time.

Alternatively I guess I could have used the divide command to place a bunch of nodes for selection on an arc.
Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
*Expert Elite*
JDMather
Posts: 26,246
Registered: ‎04-20-2006
Message 3 of 3 (34 Views)

Re: Raster images

10-09-2007 03:14 PM in reply to: rich
I tried again using Divide this time.
Can get good results with just 4 or 5 points on arc. Use more if you need it smoother.
Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community