Inventor Publisher

Reply
*Expert Elite*
mthomas
Posts: 258
Registered: ‎06-17-2010
Message 1 of 2 (188 Views)
Accepted Solution

Callouts (collect and aligning questions)

188 Views, 1 Replies
02-18-2011 11:49 AM

Two more questions about callouts...

 

1) Any way to collect callouts? As in I'd like to show two item numbers on the same leader

2) Other than aligning all the callouts on the sheet, is there some way to align only a selection of callouts

 

Thanks

 

Mike

Mike Thomas

Board Manager
Posts: 220
Registered: ‎08-23-2006
Message 2 of 2 (186 Views)

Re: Callouts (collect and aligning questions)

02-18-2011 12:18 PM in reply to: mthomas

Sorry, neither of these things is well-supported.  You have to cobble it together by hand (use a label for the 2nd callout, move the callouts one-by-one for alignment).



Jon Balgley
Autodesk Configurator 360 / Inventor ETO team
Autodesk, Inc.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube