Assembly | Positional representations: Saving in active positional rep.

[andreas.ernst-wagnerDR5T8]

I would like the ability to save within an activated positional representation. An automatic switching during the save process from "Position xy" to "Master" and back again to "Position xy" would also be an approach.

Thanks for supporting!

Regards,

Andreas

[kmeldfreyssinet]

Hi,

wouldn't it be good to be able to save assembly in positional representaions to dwf?

I think it would be greate. Now it is ot possible and I am disapointed and suprised this is not possible every time I try.

What is the point to have a project viewer if project can not be presented properly?

Cris.

[jtylerbc]

Ability to save an assembly in PosReps to DWG would be nice as well. 

[kmeldfreyssinet]

And in generall to any of avialable formats.

[alexmende]

Duplicate idea here:

https://forums.autodesk.com/t5/inventor-ideas/save-positional-representaions/idi-p/5142396

[alexmende]

Duplicate idea:

https://forums.autodesk.com/t5/inventor-ideas/assembly-positional-representations-saving-in-active-p...

Make sure to vote for both.

[Cadmanto]

I would like the positional reps to save in the position I leave them.  I have a door that I open fully in the rep.  click back to master where the door is closed, then back to the positional rep and it opens it half instead of fully.

This is very annoying!!!!