Inventor General

Reply
Contributor
Posts: 11
Registered: ‎01-18-2010
Message 1 of 1 (122 Views)

spur gear

122 Views, 0 Replies
02-23-2012 07:11 PM

Hi

 

I need a spur gear set. All my attempts have led to an error of some sort, usually a bad internal/small gear.  The specs for the set go as follows:

- large gear with inside teeth with max outside diameter of 14.5"

- a spur gear that will go inside the large gear with a .5" bore (preferably 9 teeth)

- 10 to 1 gear ratio.

- teeth on both gears should be .187" minimum height

 

Thanks

 

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube