Inventor General

Reply
Member
rgajewski
Posts: 5
Registered: ‎02-21-2007
Message 1 of 2 (111 Views)

sheet metal help

111 Views, 1 Replies
06-03-2011 09:51 AM

I'm attempting to make an inside corner, like on crown molding, but in sheet metal.  IE>. 2 pieces at 90 degrees to each other and on a 45 degree bias, that meet in the "corner".  If possible it should be made from (1) piece of metal.  I've tried sweeping a profile, but it won't allow me to unfold it.  Any thoughts or suggestions are always appreciated.
Thanks

Ray

PS:Inventor 2011

Active Contributor
macflirty
Posts: 26
Registered: ‎02-28-2011
Message 2 of 2 (81 Views)

Re: sheet metal help

06-03-2011 06:36 PM in reply to: rgajewski

can you provide a snapshot or post your ipt file.?

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube